Chemical Analysis of DG Cement's Municipal Waste Used for Refuse Derived Fuel
DOI:
https://doi.org/10.47672/ajes.1152Keywords:
Refuse derived fuel, atomic absorption spectrophotometry, calorific value, moisture content, heavy metals.Abstract
Purpose: Rampant population growth particularly in South Asian region has turned solid waste management a challenging task. Huge resources are squandered for collection and disposal without considering the recyclable and energy potential. However, in Pakistan, some companies are utilizing waste as refuse derived fuel (RDF) - a process to separate combustibles from municipal waste in order to generate energy.
Methodology: For RDF analysis, DG cement RDF plant near Lakhodair landfill site Lahore was selected in order to collect RDF raw waste, which are then converted in to RDF pellets for further analysis. The chemical analysis consisted of proximate analysis (moisture content, volatile combustion matter, fixed carbon & ash content) and net calorific value (NCV) along with heavy metal analysis.
Findings: Upon analysis, percentage of volatile combustible matter (VCM) tetra pack and jute was about 84% followed by other waste and thermo-pole 78%. Fixed carbon (FC) of wrappers and paper waste was about 24 and 16% whereas Ash content (AC) was recorded highest in textile, shoppers, thermos-pole and foam with 14% while rest 10%. The moisture content (MC) of other waste type followed by shopping bags and jute was found highest among other component such as 3.5%, 24% and 20.9% respectively. Moreover, the highest calorific value was obtained in plastic wrappers (61.26 MJ/kg) whereas lowest was observed in jute (6.4 MJ/kg). For heavy metal analysis such as Chromium (Cr), Lead (Pb), Cadmium (Cd) and Copper (Cu), Atomic Absorption Spectrophotometry (AAS) was used; highest concentration of copper was observed in the foam waste (45.5 mg/kg) and the lowest value was observed in thermos-pole (8.5 mg/kg). All the results were in EURITS standards range.
Recommendation: Therefore, in the light of above analysis, it was confirmed that collected waste is highly feasible for RDF in DG cements.
Downloads
References
Wikner, E. (2009). Modeling waste to energy systems in Kumasi, Ghana. Master's thesis in Environmental and Aquatic Engineering, Department of Energy and Technology, Swedish University of Agricultural Sciences (SLU), Uppsala, Sweden.
Haider, A., Amber, A., Ammara, S., Mahrukh, K. S., & Aisha, B. (2015). Knowledge, perception and attitude of common people towards solid waste management-A case study of Lahore, Pakistan. International Research Journal of Environment Sciences, 4(3), 100-107.
Govindaraju, M. (2011). Integrated Waste Management In Urban Areas Using Geographic Information System (GIS), Proceedings of the International Conference on Solid Waste -Moving Towards Sustainable Resource Management, Hong Kong SAR, P.R. China.
Ilaboya, R., Atikpo, E., Asekhame, F. F., Onaiwu, D. O., & Omofuma, F. E. (2011). Design of an integrated solid waste management scheme"–: a model design for Igbinedion University Community. Journal of Applied Technology in Environmental Sanitation, 1(2), 125-138.
Berkun, M., Aras, E., & Nemlioglu, S. (2005). Disposal of solid waste in Istanbul and along the Black Sea coast of Turkey. Waste Management, 25(8), 847-855.
Nations, U. (2012). World urbanization prospects: The 2011 revision. new york: United nations department of economic and social affairs/population division. UN Proceedings.
Majid, H., Madl, P., & Alam, K. (2012). Ambient air quality with emphasis on roadside junctions in metropolitan cities of Pakistan and its potential health effects. Health, 3(3), 79-85.
Cremiato, R., Mastellone, M. L., Tagliaferri, C., Zaccariello, L., & Lettieri, P. (2018). Environmental impact of municipal solid waste management using Life Cycle Assessment: The effect of anaerobic digestion, materials recovery and secondary fuels production. Renewable Energy, 124, 180-188.
Khajuria, A., Yamamoto, Y., & Morioka, T. (2010). Estimation of municipal solid waste generation and landfill area in Asian developing countries. Journal of environmental biology, 31(5), 649-654.
Gómez, G., Meneses, M., Ballinas, L., & Castells, F. (2009). Seasonal characterization of municipal solid waste (MSW) in the city of Chihuahua, Mexico. Waste management, 29(7), 2018-2024.
Oyelola, O. T., & Babatunde, A. I. (2008). Characterization of domestic and market solid wastes at source in Lagos metropolis, Lagos, Nigeria. African Journal of Environmental Science and Technology, 2(12), 430-437.
Yang, C. (2011). Municipal Solid Waste Management in an urban area of China: Case studies of Shanghai, China and Linköping, Sweden.
Akdağ, A. S., Atımtay, A., & Sanin, F. D. (2016). Comparison of fuel value and combustion characteristics of two different RDF samples. Waste Management, 47, 217-224.
Brás, I., Silva, M. E., Lobo, G., Cordeiro, A., Faria, M., & de Lemos, L. T. (2017). Refuse derived fuel from municipal solid waste rejected fractions-a case study. Energy Procedia, 120, 349-356.
Lopes, E. J., Okamura, L. A., Maruyama, S. A., & Yamamoto, C. I. (2018). Evaluation of energy gain from the segregation of organic materials from municipal solid waste in gasification processes. Renewable Energy, 116, 623-629.
Aluri, S., Syed, A., Flick, D. W., Muzzy, J. D., Sievers, C., & Agrawal, P. K. (2018). Pyrolysis and gasification studies of model refuse derived fuel (RDF) using thermogravimetric analysis. Fuel Processing Technology, 179, 154-166.
Saeed, M. O., Hassan, M. N., & Mujeebu, M. A. (2009). Assessment of municipal solid waste generation and recyclable materials potential in Kuala Lumpur, Malaysia. Waste management, 29(7), 2209-2213.
Rotheut, M., & Quicker, P. (2017). Energetic utilisation of refuse derived fuels from landfill mining. Waste management, 62, 101-117.
Gallardo, A., Carlos, M., Bovea, M. D., Colomer, F. J., & Albarrán, F. (2014). Analysis of refuse-derived fuel from the municipal solid waste reject fraction and its compliance with quality standards. Journal of cleaner production, 83, 118-125.
Grau, A., & Farr, O. (2011). Situation and potential of the direct waste energy recovery. Technical study. PER, 2020..
Chen, D., Yin, L., Wang, H., & He, P. (2014). Pyrolysis technologies for municipal solid waste: a review. Waste management, 34(12), 2466-2486.
Sharholy, M., Ahmad, K., Mahmood, G., & Trivedi, R. C. (2008). Municipal solid waste management in Indian cities-A review. Waste management, 28(2), 459-467.
Kalanatarifard, A., & Yang, G. S. (2012). Identification of the municipal solid waste characteristics and potential of plastic recovery at Bakri Landfill, Muar, Malaysia. Journal of Sustainable Development, 5(7), 11.
Manyà , J. J., GarcÃa-Ceballos, F., Azuara, M., Latorre, N., & Royo, C. (2015). Pyrolysis and char reactivity of a poor-quality refuse-derived fuel (RDF) from municipal solid waste. Fuel Processing Technology, 140, 276-284.
Sarc, R., & Lorber, K. E. (2013). Production, quality and quality assurance of Refuse Derived Fuels (RDFs). Waste management, 33(9), 1825-1834.
Downloads
Published
How to Cite
Issue
Section
License
Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution (CC-BY) 4.0 License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
