Evaluation of the Rheological Properties of Raphia Sese Oil Based Mud (Ester Oil) for Oil Field Drilling Applications
DOI:
https://doi.org/10.47672/ejt.1290Keywords:
Raphia sese oil (ester oil), drilling fluid, pollution, disposal, rheology, densityAbstract
Purpose: The environmental challenges posed by oil-based drilling fluids along with legislation associated with their use have necessitated the development of synthetic organic liquids that are able to both meet the technical and environmental requirements of the industry. In this regard, an environmentally friendly vegetable oil-based mud from Raphia Sese oil (ester oil) was formulated and its rheological properties and economics abilities analyzed.
Methodology: The rheological properties of the mud such as plastic viscosity, yield point, flow index, apparent viscosity, consistency index, dial readings, density, and pH were evaluated at unaged conditions from 80 oF to 200 oF.
Findings: The results showed that Raphia sese oil base mud was compatible with the conventional oilfield additives. Though its mud naturally recorded a low pH (8.3) due to the low pH of the Raphia sese oil (5.53), with improved extraction process and with the addition of pH additives, this could be enhanced. When compared with diesel-based mud, the Raphia sese based oil mud recorded higher density values and promising rheological properties. Though the initial cost of conditioning Raphia sese oil for mud formulation purposes was high, it was offset by its disposal cost as compared to that of diesel oil (saves about 34% the cost of using diesel).
Recommendation: From the findings, it is recommended that the recovery process of the Raphia sese oil as well as its thermal oxidation stability should be improved. Again, higher thermal conditioning testing must be done to ascertain the stability of the Raphia sese oil at higher temperatures. Also, the Congolese nation could consider the domestication of the Raphia sese palm to increase the production of its oil and the nation could go into the improved cultivation to promote local content and participation policy of the oil.
Downloads
References
Amorin, R. (2015a), “Drilling Fluids”, Unpublished BSc Lecture Notes, University of Mines and Technology, Tarkwa, 74 pp.
Amorin, R. (2015b), “Evaluation of the Rheological Properties of Antioxidated Local Oils for Pseudo Oil Base Mud Formulation for Drilling Operations”, Unpublished PhD Thesis Report, University of Mines and Technology, Tarkwa, 199 pp.
Amorin, R. & Broni-Bediako, E. (2020), “Evaluating the Rheological Properties of Antioxidated Local Pseudo Oil Base Muds for Geothermal Drilling Environment”, Ghana Journal of Technology, Vol. 5, No. 1, pp. 93-103.
Amorin, R., Dosunmu, A. & Amankwah, K. R. (2015), “Enhancing the Stability of Local Vegetable Oils (Esters) For High Geothermal Drilling Applications”, Journal of Petroleum and Gas Engineering, Vol. 6, No. 8, pp. 90-97.
Amorin, R., Dosunmu, A. & Amankwah, R. K. (2015), “Economic Viability of the Use of Local Pseudo-Oils for Drilling Fluid Formulation”, Ghana Mining Journal, Vol. 15, No. 2, pp. 81 - 90.
Anon. (2016a), “Plastic Viscosity”, www.glossary.oilfield.slb.com. Accessed: April 6, 2016.
Anon. (2016b), “Yield Point (YP)”, www.drilling-mud.org/yield-point-yp/. Accessed: April 6, 2016.
Anon. (2016c), “XE: (USD/INR) US Dollar to Indian Rupee Rate”, http://www.xe.com/currencyconverter/convert/?From=USD&To=INR. Accessed: March 30, 2016.
Bernier, R., Garland, E., Glickman, A., Marathon, F. J., Mairs, H., Melton, R., Ray, J., Smith, J., Thomas, D. & Campbell, J., (2003), “Environmental Aspects of the Use and Disposal of Non-Aqueous Drilling Fluids Associated with Offshore Oil and Gas Operations” Unpublished Technical Report by International Association of Oil and Gas Producers, Report No. 342, 114 pp.
Blay-Sam, D. (2015), “Evaluation of Rheological Properties of Antioxidated Coconut Oil Base Mud”, Unpublished BSc Project Report, University of Mines and Technology, Tarkwa, 34 pp.
Chilingarian, G. V., Alp, E., Al-Salem, M., Uslu, S., Gonzales, S. & Dorovi, R. J. (1983), “Drilling Fluid Evaluation Using Yield Point-Plastic Viscosity Correlation”, One Petro, 16 pp.
Okorie E. Agwu, Anietie N. Okon, & Francis D. Udoh (2015), A Comparative Study of Diesel Oil and Soybean Oil as Oil-Based Drilling Mud, Journal of Petroleum Engineering Volume 2015, pp. 1-10.
Udoh, F. D., Itah J. J. and Okon, A. N. (2012), “Formulation of Synthetic-Based Drilling Fluid Using Palm Oil Derived Ester”, Asian Jr. of Microbiol. Biotech. Env. Sc., Vol. 14, No. 2, pp. 175-180.
Woodland, F., Dankwah, J. R., Amorin, R. & Dabo, K., (2022), “Evaluation of the Effect of Water Hyacinth Ash (WHA) as an Additive on Local Portland Cement for Oil Well Cementing”, International Journal of Scientific Development and Research, Vol. 7, No. 8, pp. 1-11.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2022 Manuella-Grace Syllou-Kongo, Richard Amorin, Anthelme Tsoumou
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution (CC-BY) 4.0 License that allows others to share the work with an acknowledgment of the work’s authorship and initial publication in this journal.
